Description_of_the_Experiment2

3.2.3.1 Description of the Experiment

By means of holographic interferometry using the double-exposure method, many experiments were carried out in order to reveal the time dependency of the wood joint thermal deformation. The infrared source (type P-511, performance 500 W) in the distance of 400 mm from the test specimen was used for heating.

In the experiments only the wood joint was taken into consideration irrespective of the upper (cover) and lower (base) parts. The test specimen used in the measurements (Fig. 3–38) was cut out of a long wood beam with the dimensions 120 × 120 × 60 mm, inside which was a tongue measuring 40 × 40 × 60 mm. The record of the thermal flow was obtained by measurement of the tension in the joint during the holographic experiments. For this purpose the thermo-elements set on the other side of the joint were used.

Before the final experiments the optimal time interval for both the measurement and analysis of the thermal deformations was sought for.

Before the first measurement, the thermal source – the infrared radiator – radiated heat on the test specimen for 30 minutes, then the record was inscribed on the holographic plate.

30 minutes later, the first exposure was made and the second one was made after the other four minutes of heating.

In Tab. 3.1 the time interval of heating and cooling of the test specimen for all measurements is shown.